Kawasaki ZX-10R Forum banner
Status
Not open for further replies.
1 - 11 of 11 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
Im building a four wheeler with an 07 zx10 engine, Im trying to make it crank but the fuel pump is not comming on, and the coils are not fireing.

fuel pump works on 12v hardwire

I tried the 100ohm resistor thing no luck ( dont know what wires)

spins over fine

twisted 2 outter wires on tip sensor together kickstand bypassed.

any help is appreciated
 

·
Registered
Joined
·
137 Posts
I feel mod coming down from above.
Do a search on this question, it has come up b4.
Ergo
 

·
Registered
Joined
·
8 Posts
Discussion Starter · #3 ·
I feel mod coming down from above.
Do a search on this question, it has come up b4.
Ergo
Ive searched this forum along with many others for the answer and come up empty handed. A few have asked the question, only one had the answer but it is all the wrong wire colors for my bike.
 

·
Registered
Joined
·
268 Posts
Thats going to be one wild 4-wheeler :eek:ccasion1
 

·
Registered
Joined
·
8 Posts
Discussion Starter · #6 ·
Thats going to be one wild 4-wheeler :eek:ccasion1
Thanks! I had hoped so, but Im seriously thinking about scrapping the whole thing and just putting a cbr600rr engine in it, I know how to make those run. I cant seem to get any answers on any forums regarding my issues with this one and the time ive spent trying I could have had the other one going already.
 

·
Registered
Joined
·
51 Posts
Make sure you have the clutch switch tied together , tip over sensor tied, and side stand tied if you are not using any of those. There is also one wire that need temporary power to start, don't remember the color.
We cut down the harnesses completely.
 

·
Chickenstrip Eater
Joined
·
4,075 Posts
Needs more duct tape.
 

·
Premium Member
Joined
·
4,394 Posts
Sorry folks, but this is off limits discussion, because it could be used by thieves to steal a bike.
 
1 - 11 of 11 Posts
Status
Not open for further replies.
Top