Kawasaki ZX-10R Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
86 Posts
Discussion Starter · #1 ·
Does anyone here installed Yana Shiki frame sliders on their 10R? I purchase a set from Star Rotars and it do not come with instructions to where to mount the sliders. I tried to contact Yana Shiki over a week ago but they did not reply, very poor service. You would think they might have pictures for show in their catalogue.:headshake

Any help is much appreciated!:thumbsup:
 

·
Registered
Joined
·
2,213 Posts
Looking at the website, they might mount similar to mine.

http://champindustries.net/dir_zx10g3.html

I have a couple sugestions. Use diferrent bolts. The picks show black oxide coated bolts. Swap out for zinc plated, no rust that way. And get longer bolts with a nut on the back side. Without it could rip right out. O way thats for the plate mounted sliders. The 08 is more a direct mount. :) Are the sliders actually aluminum?????
 

·
Registered
Joined
·
86 Posts
Discussion Starter · #3 ·
Looking at the website, they might mount similar to mine.

http://champindustries.net/dir_zx10g3.html

I have a couple sugestions. Use diferrent bolts. The picks show black oxide coated bolts. Swap out for zinc plated, no rust that way. And get longer bolts with a nut on the back side. Without it could rip right out. O way thats for the plate mounted sliders. The 08 is more a direct mount. :) Are the sliders actually aluminum?????
Hmm, that does look like mounting the same way as yours. Star Rotars told me there is no need to modify body works for these sliders. I don't like the idea of cutting holes in a perfectly fine body work.

I think they are aluminum, they feel heavier than it looks.

Thank you for the help:thumbsup:
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top