Kawasaki ZX-10R Forum banner
1 - 1 of 1 Posts

21 Posts
Discussion Starter · #1 ·
Dear Friends

I have purchased the keyswitch eliminator for the 2011 ZX10R. My bike is an AU model. The keyswitch eliminator has a white 4 pin plug, which from the wiring diagram fits the USA model. Whereas the AU model has a with 3 pin plug leaving the yellow wire nowhere to fit. This yellow wire appears (i'm not elec. wise at all) to be a second ignition wire from the switch. The switch doesn't work on my model. So i'm thinking this yellow wire would need to be connected to the 1 red/brown ignition wire on the AU plug?
Any advice from the electrical peeps out there would be appreciated, before i go and short something :confused:



1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.