Kawasaki ZX-10R Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
54 Posts
Discussion Starter #1
Hi Guys,

Asking your advice where to install Wideband o2 sensor mount.

I have stock header, Akrapovic titanium link pipe and Akrapovic Slip On (see attached photo, I marked few possible locations).

I've understood if I use narrowband to wideband adapter and mount sensor on stock bung, readings are not accurate?

I have also difficulties to find welder who could successfully weld bung on titanium link pipe.

I saw that there are no weld o2 wideband mounts available. How these works in practise? Lifetime / possible leakages?
No-Weld O2 Sensor Mounts | AEM

Should I remove stock narrowband bung and weld wideband bung on it or?

All recommendations would be very welcome.

Thanks.
 
1 - 1 of 1 Posts
Top