Kawasaki ZX-10R Forum banner

1 - 11 of 11 Posts

·
Rent this space
Joined
·
6,590 Posts
Its meant to be a good product with a very good boiling point, I dont think you will have any problems with it.
 

·
Registered
Joined
·
941 Posts
Discussion Starter #3
Ok man thanks. Just wanted to make sure. Now I need to go bleed the master cylinder. I didn't know I needed to, but that probably explains why I only have half lever.
 

·
Registered
Joined
·
941 Posts
Discussion Starter #6
Going to do it right now. If you don't hear back from me in a while, I guess I screwed up, right?
 

·
Registered
Joined
·
1,271 Posts
Used it with no problems.
Using Motul 5.1 at moment. Need to get the new brakes on to get the new feel down.
 

·
Registered
Joined
·
941 Posts
Discussion Starter #11
Ok I'm back. The brakes are awesome now. Combined with the 6r Calipers, this thing stops on a dime. I followed the stock routing for the lines, not thinking about sending one to each caliper. Now I guess I get to do it again.
 
1 - 11 of 11 Posts
Top