Kawasaki ZX-10R Forum banner
1 - 6 of 6 Posts

· Registered
Joined
·
1,026 Posts
Discussion Starter · #1 ·
hey guys, happy thanksgiving to you all,


can somebody point me in the right direction of the valve wedge tool? Im about to do my valves and want to get a reliable clearance gauge.

thanks guys
 

· Registered
Joined
·
44 Posts
Try ENCO. They have feeler guages and shim stock that's supplied for the machining and metalworking industry. Just a suggestion, but buy the set with the approx. 30 degree angle bent on them, makes it easier to get under the buckets. Here's a link to the pages with feeler guages.

http://www.use-enco.com/CGI/INPDFF?PMPAGE=392&PMCTLG=00
 

· Registered
Joined
·
1,026 Posts
Discussion Starter · #5 ·
thanks

i haven't dealt with the feeler gages before, but i would like them to have more "resolution".


Id like them to be more detailed from .10mm to .30mm. All these seem like they only have .1, .15, .2, .25mm etc. would this be enough to effectively measure the correct gap size?
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top