[Older Guy]

See if you can figure this one out.

My turn signals work fine when I start out and after an hour ride.

When I I go to end my ride and get gas, they don't work.

When I pull into the garage, they don't work.

After the bike cools off, they work fine...

Suggestions?

 

[scout]

You wash your bike...as in using the hose.

 

[Older Guy]

You wash your bike...as in using the hose.

Never do...

 

[bidwell427]

They do not light up at all or just don't blink? If the latter it may be the flasher.

 

[Older Guy]

They do not light up at all or just don't blink? If the latter it may be the flasher.

once it gets warm, nothing happens...dead...

 

[G37Sam]

Could be your blinker fluid running too hot haha

 

[bidwell427]

That's damn strange, I would still try changing the flasher. Its the only thing in the electrical chain that could act up, the rest is just hard wiring and a switch.

 

[Porschenut]

I 2nd the flasher relay if you're using aftermarket LED tail lights. Mine went wonky and it was the relay. A buddy's relay also just gave up the ghost even though it had very little use.

At least it's a cheap fix!

 

[Older Guy]

YUP..put in the stock flasher and it worked fine, but fast due to LED's. I bought a relay flash device from Amazon and it worked fine until I hit the road then it blinked faster at higher engine speeds. The TST unit I replaced worked fine for 6 years so I assume it just went bad and I should just get another one of those....I'm calling TST Monday.