Kawasaki ZX-10R Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
153 Posts
Discussion Starter #1
any suggestions on a heavy duty clutch and springs ????????????
 

·
Registered
Joined
·
974 Posts
Hayes Billet basket.......Barnette or EBC springs........stock fibers and steels....KO combo
 

·
Registered
Joined
·
1,483 Posts
Cheapest route: have the rivets on your stock basket welded. You're not going to be drag racing, just street roll-ons. Never heard of the GSXR springs, that sounds nice and cheap. You can install 3 heavy and 3 OEM, probably all you need for 6psi. If it slips in high gear, add more spring.
 

·
Registered
Joined
·
153 Posts
Discussion Starter #7
Ordered a set of heavy duty springs . and gotnna use stock friction plates and steel plates till they go thanks guys prob do the weld on the rivits good idea
 

·
Registered
Joined
·
2,161 Posts
rivets are too skiny, they will still break even if you weld them, get an 04-05 jadder spring and it'll make 2nd gen clutch feel so much better.
 

·
Registered
Joined
·
104 Posts
In my 2010 zx10 drag bike I run brocks springs with spacers, cycle concepts drag pak and hays billet basket. pretty much a bullet proof clutch setup.
 
1 - 9 of 9 Posts
Top