Kawasaki ZX-10R Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
21 Posts
Discussion Starter #1
hey i need to know the voltage range for the tps from 0 % and then also 100% throttle and the color of wire i should tap into for a signal
i am wanting to install a daytona wego III wideband that i just bought off the site thanks
 

·
Registered
Joined
·
76 Posts
The TPS wire at the ECU you will need to tap into is a yellow/white wire. You can check the voltage between the yellow/white and the brown/black wire at the ecu. I believe pin 26 and 34 i think. Voltage should be about 0.6 at idle to about 3.9 at WOT. Hope that helps.
 

·
Registered
Joined
·
819 Posts
When you tap into it you can go into the wego and see what its putting out and then adjust the parameters as such:thumbsup:
 

·
Registered
Joined
·
21 Posts
Discussion Starter #4
thanks guys also would it be possible to just tap into the power commander tps signal instead of the factory harness and if so what wire lol thanks
 
1 - 4 of 4 Posts
Top