Kawasaki ZX-10R Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
113 Posts
Discussion Starter #1
Hello Forum, Does anyone know the torque spec for the bolts that holds the caliper to the forks on a zx10? :dontknow:
 

·
Registered
Joined
·
2,128 Posts
25 ft-lb.... just checked the manual for ya.
 

·
inappropriate
Joined
·
7,728 Posts
like anything else i tighten... "gouttentight"
 

·
Registered
Joined
·
113 Posts
Discussion Starter #7
Thanks, fellow.. good looking out!!!! I also found the manual on the forum, so I downloaded it for safe keeping.... Well i'm gonna go ahead and put my story out ... A buddy and I had then tighten at 35 lbs. oooppppppppps
 

·
Registered
Joined
·
2,128 Posts
35 isn't too bad. I'd probably take it to that honestly. A ton of bikes go to 33fl-lbs so no worries. That's still not a lot of torque on them.
 
1 - 8 of 8 Posts
Top