Kawasaki ZX-10R Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
123 Posts
Discussion Starter #1
I just recieved my HID kit, and am trying to figure out the best place to mount the ballast on my 07. Anyone have any suggestions? Also, which wire is pos and neg on the factory plug to the H11 bulb?
 

·
Registered
Joined
·
736 Posts
Don't use the tape that comes with the kit. Go to Home Depot and use 3M double sided.

Most people jut fit the ballast wherever they can find room, there's not a whole of room.
 

·
Registered
Joined
·
1,455 Posts
I have mine zip tied to the subframe in the rear. Where the tail of the bike flares out and back in ...behind it. I had to extend 2 wires to go up to the front but...cant see them and theyre out of the way!
 

·
Registered
Joined
·
1,508 Posts
Does the hid mod make a lot of difference?
 

·
Registered
Joined
·
2,091 Posts
I used the double sided 3m tape and stuck them inside the fairing. One on each side.

Check out this thread:

http://zx-10r.net/forum/showthread.php?t=13483

There is alot of information you can find in this forum by using the search button.
 

·
Registered
Joined
·
1,113 Posts
Mine are on the inside of the inner fairing, right beside the forks. Used double sided 3M and no problems in about 5000 miles.
 
1 - 7 of 7 Posts
Top