Kawasaki ZX-10R Forum banner

1 - 14 of 14 Posts

·
Registered
Joined
·
1,938 Posts
Discussion Starter #1
Ive looked at alot of pics on here of y'alls bikes and most still have left over sticker residue on their swing arm. For those that are not sure how to remove that hard as a rock glue, here is how I did it.

1) clean the swing arm with hot soapy water
2) apply Goo Gone to the area with your fingers and kinda massage it in
3) let it set on there for about 15-20min
4) take the soft plastic cap "dont use metal" to gently remove in a back and forth motion
5) repeat steps 2 thru 4 until completely removed
6) Wash with hot soapy water
7) Ride
 

·
Dont mess wit White Ninja
Joined
·
5,932 Posts
I ripped it off, threw on some handy dandy spray cleaner and wiped her off. All gone, but nice write up!!
 

·
Dont mess wit White Ninja
Joined
·
5,932 Posts
yeah, I used an aluminum degreaser spray that I use on my rims and certain area's and it worked great!!
 

·
Registered
Joined
·
255 Posts
sticker removal

Steal your lady friends hair dryer. Apply heat, remove sticker.... Lil brake clean on rag and remove the left over glue (DO NOT USE ON PLASTIC!!!). Use polish for finishing touch....:spit:
 

·
Registered
Joined
·
3,561 Posts
it not that difficult to take a sticker off a swingarm
I would never dream of starting a thread about it.
retard.
 

·
Registered
Joined
·
4,818 Posts
Ronsonal lighter fluid. Works WAAAAAAYYYYYYYY better than goo-gone...and evaporates away. You're welcome! :wink:
 

·
Registered
Joined
·
4,818 Posts
it not that difficult to take a sticker off a swingarm
I would never dream of starting a thread about it.
retard.
Don't hate...educate! :badteeth:
 
1 - 14 of 14 Posts
Top