Kawasaki ZX-10R Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Thanks in advance for the replies.

I recently installed my stator but in the rush i was in i installed it upside down. So the wires had been cut through completely and never worked.

On to my question. I can repair these wires but i am wondering the best way to do it?

1. Solder? then heat shrink?
2. Innertwine the wires then heat shrink?
3. Use a connector then heat shrink?

Or if you have a better way, i really dont feel the need to spend another $140 but i will if i have too..

Thanks!

P.S I have enough for for the wires and they were cut clean through bike was only driven for about twenty minutes until i realized the battery was not charging.
 
1 - 3 of 3 Posts
Top