Kawasaki ZX-10R Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
349 Posts
Discussion Starter #1
I'm trying to set the 2nd setting on my speedohealer. I want to set the other setting up so I can just use the button to switch from one to another if I change set ups such as sprockets or anything like that. I can't seem to figure out how to though. Any help would be appreciated. Thanks.
 

·
Registered
Joined
·
349 Posts
Discussion Starter #5 (Edited)
So how do you set the 2nd setting?? Also is that 2nd setting changeable through the button?? When I try and put the other setting in it only shows the L and the - so i'm not too sure how i'm supposed to get to that other setting.
 

·
Registered
Joined
·
349 Posts
Discussion Starter #7
Don't like to use the interweb?

http://www.healtech-electronics.com/docs/SHv4_UsersGuide_en.pdf

"3.5 Switching between A and B calibration value
Press SET until the active memory bank ([A] or ) is displayed and keep it depressed for one more second, until the value switches.
�� When you program a calibration value (chapter 3.2), you can program the value in the active memory bank only."


I tried looking online and here before I posted... apparently not good enough though... :thefinger

Either way. Thanks a lot man. I appreciate you finding that and sharing. :eek:ccasion1
 
1 - 8 of 8 Posts
Top