Kawasaki ZX-10R Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
308 Posts
Discussion Starter #1
Ok... I know a few of you out there have done this. I'm taking apart my speed sensor connector on the harness side. I'm doing so to install a speedo healer that's meant for a gen1.

I know how to wire it. I've disassembled the connectors on the healers side. It's the connector on the bike I'm having trouble with. Anyone have any tips? I feel dumb for asking but I'm to the point of ripping it apart (which I don't want to do) I see tabs underneath the pins that I would think I can push down and then slid out the pins, but for the life of me I can't push the tabs down and get the damn things out. I'm I doing this right? any help is appreciated.
 
1 - 1 of 1 Posts
Top