Kawasaki ZX-10R Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
141 Posts
Discussion Starter · #1 ·
Hi,

I was wondering if everyone had the same thing as I do, but whenever I insert the key in the ignition module, I almost need to hammer it down with my first for it to get through the last pin inside, it's really stiff.

Not to mention the small door preventing stuff from going in doesn't shut even anymore.
I slightly bent my key this morning trying to put it in (it was a cold morning though, 25F-4C).

I hope I'm not alone and it's a regular behavior, otherwise my warranty ran out 4 days ago...
It was smoother when I got it, that's for sure.
 

·
Registered
Joined
·
141 Posts
Discussion Starter · #3 ·
I put a small amount of an anti-freeze bottle for door locks this morning and it helped a bit, but the issue was back at noon (alcohol probably evaporated). I'll try WD40 and see if it helps.
 
1 - 3 of 3 Posts
Top