Kawasaki ZX-10R Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
76 Posts
Discussion Starter #1
Im upgrading to a set of 08CBR600 calipers, so I'm going to be putting a new set of lines and HH sintered pads in. The question is on the stock rotors am I going to have to smooth them out to get a smooth surface? If I do what is the easiest and best way to accomplish this?
 

·
Registered
Joined
·
700 Posts
You can bead blast them. It cleans them and helps the new pads seat. Or just ruff them up with some 400 grit sandpapper.
 

·
Registered
Joined
·
1,359 Posts
I never really had any issues when I made the change at about 12,000 miles. My brakes are awesome, and although the rotors are towards the end of their life, they have done me well.

The only thing I did was clean them off real good.
 
1 - 3 of 3 Posts
Top