R&G or???? UPDATED

1015 Views 4 Replies 3 Participants Last post by Helitech, Jan 25, 2017

Helitech

Discussion Starter · Jan 21, 2017 (Edited)

R&G or???? UPDATED

Ok guys and gals, here it is. Looking to finish off the bike (until my rear link plates and gen 5 shock get here) with a couple fine touches. I was interested in the following from R&G:

- exhaust hangar and blank off plate
- radiator guard
- carbon tank protector
- carbon tail protector

Can anyone think of an R&G or Evotech retailer in the states? Shipping to where I'm stationed overseas would take longer than I'd like.

Or can anyone suggest another company for these things specifically?

Post pictures if you've got them! Thanks again!

Sent from my iPhone using Tapatalk

Save

1 - 5 of 5 Posts

obijack

· #2 · Jan 21, 2017

I would use evotech for rad guard. R&G uses zip ties, where the evotech doesn't. The evotech fits much better. I emailed them and they gave me a better price than what was listed on thier website. It was still cheaper than ordering it from a USA vendor. I have their frame and axle sliders, radiator guard, and tail tidy.

Save

Helitech

Discussion Starter · #3 · Jan 21, 2017

Thanks for the reply

Sent from my iPhone using Tapatalk

Save

sdiver68

· #4 · Jan 21, 2017 (Edited)

I used R&G tank sliders on my ZX-6R race bike. Was very impressed with how they came through virtually unscathed after a low side. I can't speak for any of their other products but the carbon tank sliders are quality.

See less See more

Save

Helitech

Discussion Starter · #5 · Jan 25, 2017

obijack said:
I would use evotech for rad guard. R&G uses zip ties, where the evotech doesn't. The evotech fits much better. I emailed them and they gave me a better price than what was listed on thier website. It was still cheaper than ordering it from a USA vendor. I have their frame and axle sliders, radiator guard, and tail tidy.

Can you post pictures of the how bright the light is for the tail tidy, and if you have time, measure the distance between the license plate mount holes at the furthest point? I'm trying to see if the tail tidy would fit my Japanese license plate.

Sent from my iPhone using Tapatalk

Save

1 - 5 of 5 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

R&G or???? UPDATED

Helitech

obijack

Helitech

sdiver68

Attachments

Helitech

Top Contributors this Month