Quick release gas cap question

839 Views 5 Replies 5 Participants Last post by MTFDarkEagle, Oct 23, 2016

MTFDarkEagle

Discussion Starter · Oct 20, 2016

Hi all!

I have a question.
Does anyone know of or use a quick release gas cap for the gen1 which uses the stock/OEM screws?

I've come across lots of gas caps, but I suspect most (if not all??) of them use a set of screws which come with it.
Because I've got nice titanium screws I'd much rather use those.

So if anyone know of a quick release (or screw even) gas cap I'd love to hear!

Thanks in advance!
Lukas Mathijsen

Save

1 - 6 of 6 Posts

dricked

· #2 · Oct 20, 2016

Pretty sure they use the stock screws. My vortex cap did anyway.

Save

ukzx10r

· #3 · Oct 20, 2016

My old cheap chinese one used standard bolts and was nicely made too

Save

blink.

· #4 · Oct 20, 2016

My vortex used the factory hardware.

Save

EvokedPotential

· #5 · Oct 22, 2016

I have both Vortex and Rizoma, both used the OEM holes, just not all of them.

Save

MTFDarkEagle

Discussion Starter · #6 · Oct 23, 2016

Muchos gracias gentlemen for the replies

EvokedPotential said:
I have both Vortex and Rizoma, both used the OEM holes, just not all of them.

OEM holes is ...well... "obvious". Question is/was if the OEM hardware (i.e. screws) is used, or are other screws provided (i.e. countersunk screws or something).

Save

1 - 6 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month