Kawasaki ZX-10R Forum banner

1 - 8 of 8 Posts

·
Banned
Joined
·
808 Posts
Discussion Starter #1 (Edited)
Can you measure the inner width between pipes? I wanted to do fender elimination today, and my license plate is too big to fit between stock pipes (can you imagine that??? :eyecrazy: )...

Maybe the width with acro pipes would be different - wider? Then i'll have to wait till i get pipes....

Thanks a lot !!



I attach the pic to show what i mean
 

Attachments

·
Registered
Joined
·
34,537 Posts
yea some of the countries have plates the size of Manhatten for fugg sakes!! :spit:

BD
 

·
Registered
Joined
·
5,228 Posts
Why not cut the license plate a little or bend it or mount it on the swingarm? That would be cheaper than buying new cans.
 

·
Banned
Joined
·
808 Posts
Discussion Starter #5
Well i was going to buy cans anyway so just wanted to know if i need to do something else or just wait for them....and yes, they made license plates wider recently ....damn crazy ppl.

Will think about bending edges only or smth like that, but still it would be good to know if akrapovic is wider than stock ...
 

·
Registered
Joined
·
344 Posts
i just put my whole rear together, I would loosen the cans at the "y", and adjust them, or add washers to get the cans farther apart. its just a few bolts.
 

·
Registered
Joined
·
384 Posts


That plate is just under 7 1/4 " wide, you have a hair under 8 1/2 " total in between the cans
 

·
Banned
Joined
·
808 Posts
Discussion Starter #8
Thanks! 8.5" thats the same as stock. Will have to play with widths, not much needed (.5" to add).
 
1 - 8 of 8 Posts
Top