Kawasaki ZX-10R Forum banner
1 - 1 of 1 Posts

· Registered
153 Posts
Discussion Starter · #1 ·
Hello all. I just installed my sppedohealer with the Kawasaki III harness and they call for you to stick it in the one harness near the clip you have to remove the wires to make your own plug ins. I temporarily stuck my power wire in that harness(where you have to slide the rubber cover down to get at it). I was wondering to whoever did this, where/how did you run that power wire. It calls to hook it up to a switched power wire. Maybe a pic if possible. I know this applies to 06-up models using a V3 Healtech speedohealer. Thanks in advance!
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.