Kawasaki ZX-10R Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
37 Posts
Discussion Starter #1
Need some advice fellas, I bought a pc3 USB from a fellow member who listed it as for a 2008 zx10r, I installed and mapped according to instructions and bike ran like crap. So I re verified the install was correct, resent the map from Dynojet to the unit and tried it again. Same rough response, next I called Dynojet and the tech verified my serial number of the unit, the answer I received is that the pc3 I bought is for a 2008 zx14r. I called the guy I bought it from and told him the issue, he said that the zx14 and zx10 power commanders are the same thing. He walked me through loading the map and I'm still having the lack of performance issue. Is this statement true?
Need to know for sure before I proceed any further, and will this cause engine damage if left installed.
Thanks all
 
1 - 1 of 1 Posts
Top