Kawasaki ZX-10R Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
402 Posts
Discussion Starter #1
New to ZX10R and honestly to fuel injected bikes overall. I have had old school gixxers with flat slides and different tuning. I have questions on my first PC III install.

Does tank require to be emptied to be hinged up to get to connectors?
Do I map this prior to putting on bike?
Do I download map and put it on PC III directly?
Where do I get the map for my BOZ B2?????or just open heaeer map, basically same thing.....
Any tips fjro install???Thanks
 

·
Registered
Joined
·
201 Posts
1. No...The tank doesn't need to be empty. But my personal preference is to remove the tank all together. It doesn't take much more, and it give you a lot more room to work with.

2&3. If you don't have access to a laptop, then the only way to get the map on the bike is to put it on the PCIII before putting it on the bike.

4. Powercommander should have a map on their website. If not, try the maps posted by members here.

5. Just follow instructions... It's not too bad of an install.

Good Luck!!
 

·
Registered
Joined
·
1,775 Posts
A Very EASY Install. +1 Above. Also in the instructions you got with your PC (which I am guessing you should've gotten ; new or used) it is VERY detailed. If you do not have instructions you can DL them from DJ's site.
 
1 - 3 of 3 Posts
Top