Kawasaki ZX-10R Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hi There, I’m in NewZealand and race an Open Wheel Lightning Sprint, have just installed a 2008 zx10r. Had an ECU flash done then onto dyno for tuning, for some reason a sensor is telling it that it needs more fuel than necessary, fuel pressure set at 43psi but far too rich, went as low as 28psi and ran spot on , but this is risky as it may lean it out at some point if the the sensor decides to work.
Ha anyone encountered this or can someone help.
cheers Andy.
 

·
Registered
Joined
·
1,246 Posts
Did the flash turn off the O2 sensors? Are you using the MAF sensor?? from original air box? Reset the fuel pressure immediately.
 
1 - 2 of 2 Posts
Top