Kawasaki ZX-10R Forum banner

Ohlins Race SCU for Sale ($250 shipped)

2602 Views 17 Replies 6 Participants Last post by  tdh
Ohlins Race SCU for Sale ($250 shipped) - SOLD!

SOLD!

I have the Ohlins Race SCU for sale that will fit in a GEN4 or GEN5. I've been using it in my GEN4 but am switching to a manual damper. The Race SCU definitely works better than the stock SCU.

See less See more
1 - 18 of 18 Posts
Hi sent you a PM but if you don't get it then email me at [email protected] and we can discuss VA deal for the scu

Thanks
Sure. Looks like you're in the UK. Anyone know what I could expect it to cost to ship a small box like this from the Midwest to the UK? I have no clue.
Yowzers! I just did a calculation on the FedEx site and it looks like the cheapest shipping rate to the UK would cost me $110! Can that be right?
Yowzers! I just did a calculation on the FedEx site and it looks like the cheapest shipping rate to the UK would cost me $110! Can that be right?
I wouldn't doubt it! I just had to send a tire back to Revzilla for a warranty and it was $88 for a Saran wrapped tire.
Try flare rate through usps.
I think if I did the calculation on their site right that would only be $33 for a small box flat rate. Much better!
  • Like
Reactions: 1
Sent you a private message.
Payment received. I'll ship it out tomorrow. Thanks!
Oh, PM me your address! :)
Sold! Mailed it out this morning.
Sold! Mailed it out this morning.
How did you like the race SCU as opposed to something like a GPR or K-Tech adjustable one? I don't mind saving a few bucks going electrical vs. mechanical but if a new SCU simply isn't going to cut it I don't want to take extra steps.

Also, what kind of difference did you notice over stock? Just curious to know... I'm good with stock for now but who knows what next season holds.
I had 2 ZX10s with the electronic damper (still have the 2016). I replaced both of them with a revalved Ohlins. I don't like the ESD even with the race SCU. I like being able to adjust it where I want it.
  • Like
Reactions: 1
I have a kit harness and Ecu, still get warning light with it turned off and unplugged. Any insight?


Sent from my iPhone using Tapatalk
Electrical tape over the light? I do that for my ABS light. :)
  • Like
Reactions: 2
1 - 18 of 18 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top