Kawasaki ZX-10R Forum banner

1 - 15 of 15 Posts

·
Registered
Joined
·
32 Posts
Discussion Starter #1
Just traded my RSV4RF for a new 18 ZX10RR
Love the ZX10RR getting upgrades anyone out there with ZX10RR please hit me up I have questions on the bike .

Sent from my SM-N960U using Tapatalk
 

·
Registered
Joined
·
714 Posts
Yes, I had EDR flash my ECU. He uses custom in house ETV maps, fuel and ignition maps etc.

Its practically unrideable without a flash IMHO. I don't know how some people do it.

I have not installed bar end mirrors. With the signal integrated into the mirrors, fabbing up front signals appears to be more effort that I want to put into it.
That said, I have a set of CRGs that would mount up nicely.

Here is what I have done to mine so far (I just hit 530 miles)
ECU Flash
FiTech Autotune
Graves cat delete low mount half system
-1 front sprocket
Cox radiator guards
Sato Rearsets
ABS dongle
Vesrah XX brake pads
Superbike Grips
Light Smoke ZeroG Corsa windscreen
Graves Tail Tidy
GB Racing case covers
Shogun Frame sliders
Rear spools
PAIR valve delete
Ram Air flapper delete
EXUP valve and servo delete
Ohlins manual Steering damper

As a side note, the brakes feel much better with ABS disabled. Kinda vague with ABS on.

I ride mostly in KTRC Mode 3, ABS off, Full Power, KEBC on Low, and QS up/down active. It wheelies just a little when I want it to, but not like the BMW which is wheelie on command.

SuperCorsas will be replaced with Dunlop Q3+s soon, and Q4s for the track.
Will also be going up to a 41 tooth rear sprocket this week.
 

·
Registered
Joined
·
32 Posts
Discussion Starter #11
That awesome I'm looking for a location that does ECU flash I'm willing to mail my ECU to get it done. Work is slow so I'm going to hit up EDR and a few other places . I put on the rage cycles turn signals. That why I'm asking about bat ends the bar is threaded don't see anything that would work for it

Sent from my SM-N960U using Tapatalk
 

·
Registered
Joined
·
714 Posts
I'm pretty sure the threaded end unbolts from the bar end....at least that's what it looked like when I was swapping grips.
Otherwise, CRG makes adapters.

I can recommend EDR, or Nils up in Seattle.
Others here have had good luck with Schnitz, and Woolich.
 

·
Registered
Joined
·
32 Posts
Discussion Starter #13
I'm pretty sure the threaded end unbolts from the bar end....at least that's what it looked like when I was swapping grips.
Otherwise, CRG makes adapters.

I can recommend EDR, or Nils up in Seattle.
Others here have had good luck with Schnitz, and Woolich.
I really appreciate your input I'm going to start with EDR, and Shinitz . CRG I'm going to look into it I'm definitely going to get me some CRG if that the case

Sent from my SM-N960U using Tapatalk
 

·
Registered
Joined
·
32 Posts
Discussion Starter #14
Do you by any chance ordered the PA2 frame sliders for your 10rr you mentioned shougun frame sliders?

Sent from my SM-N960U using Tapatalk
 

·
Registered
Joined
·
714 Posts
Not the PA2. Mine do not have replaceable ends, and they are tapered.
 
1 - 15 of 15 Posts
Top