Kawasaki ZX-10R Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter #1
Hi everyone!
Could anybody post kill timings for Gen5 stock qickshifter?
I have a some troubles with tune a Woolich quickshifter. Default kill timings are not working properly.
 

·
Registered
Joined
·
24 Posts
I think you need the race tools software to adjust kill times. The stock woolich software just adjusts sensitivity, no kill times. Was thinking about getting tje race tools myself just for that. It's getting annoying with tje qs timing. That was told to me by woolich tech support about needing the race tools.
 

·
Registered
Joined
·
8 Posts
Discussion Starter #3
I have the race tools software! )
But default kill timings are not working properly. At high RPM I have strong punch under my ass )))
 

·
Registered
Joined
·
2,715 Posts
I dunno on the zx10r stock timing but for the older dynojet quickshifters you'd either throw it at 60ms across the board but to tune it up usually you'd start at 65 and go down by 5 each gear you go up. so start at 65ms from 1-2, 60 2-3, 55 3-4 and so on. sometimes you'd find once you hit one level thats it so maybe you stop at 50ms for the top 3 gears. takes some fine tuning and a dyno makes that really easy
 

·
Registered
Joined
·
8 Posts
Discussion Starter #5
Thanks! I have set timings:
1-2 - 100 ms lower 8000 rpm, 80 upper 8000 rpm
2-3 - 80 and 65
3-4 - 80 and 60
4-5 - 70 and 55
5-6 - 60 and 50

Unfortunately I have not easy access to dyno at my location.
Do you know how timings depend on throttle %?
 
1 - 6 of 6 Posts
Top