Kawasaki ZX-10R Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
20 Posts
Discussion Starter #1
So I found a good deal on a TI force full exhaust and went ahead and bought it. As I saw a few discussions on here about them.
I had a lot of issues with bad welds on my stock exhaust system by previous owner and needed to just replace the whole damn thing.

My question is one. Do I have to replace the exhaust gasket when I go to change the heads?

And two what other brands of mufflers would you guys go with as im replacing this TI can its beat up. I was thinking about going with a M4 street slayer or SC project can???

And general thoughts on the TI force headers would be appreciated as well!
444618
 

·
Registered
Joined
·
300 Posts
Definitely replace the copper exhaust gaskets.

Ti-Force header is on par with all the great Japanese titanium exhaust.

I went with a LadyBird GP can on mine.
Keep in mind you will need a 60mm inlet muffler with a spring mounted design.

444622
 
1 - 3 of 3 Posts
Top