Kawasaki ZX-10R Forum banner
1 - 15 of 15 Posts

·
Registered
Joined
·
71 Posts
Discussion Starter · #1 ·
as you who seen my build thread. i have started with nothing and have built this bike. only thing left is fix dent in tank and paint it,blinkers and rear tail for brake

i bought this bike laid down and i do not know the wiring for the rear tail light.


ok...

i have no pig tail off the rear tail. 3 poles inside so i put female wire clams on the end and mounted them onto the poles in the rear tail light.

i do not know the location of what they do. so i am thinking tail light +, - and then other is passive for the brake light.

i have a small black plug 2 wire with black/yellow and red with a speck on it.
i have 2 bigger grey plugs i think they are to blinkers.
then i have a stran that has 3 wires blue/grey,black/yellow,red/spec

here is a pic below.




please help. i need the brake lit up tonight.
 

·
Registered
Joined
·
23,477 Posts
what year is your bike.....you always need to state everything when asking for help...with that said my bike 04 looking at the pic starting from left(where the stamp on housing says 13.5V) to right on the rear taillight

1st terminal- connects to the RED wire with gray bars
Middle terminal -connects to the Blue wire with gray bars
3rd terminal connects to the BLK/YLW wire


bloo
 

·
Registered
Joined
·
23,477 Posts
forgot to add out of the 3 connectors the 1 that is different is the License plate light the other 2 are for rear blinkers.

bloo
 

·
Servo's Eliminatus ;)
Joined
·
6,820 Posts
I'll call you tomorrow when i can get free.

I will bring my volt meter and a spare tail light to see if that one you were

talking about is bad. If it is, I know where you can get it fixed.
 
1 - 15 of 15 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top