Kawasaki ZX-10R Forum banner
1 - 11 of 11 Posts

·
Registered
Joined
·
3,152 Posts
Discussion Starter · #1 ·
What to do? I just removed my stock exhaust w/slip on and installed a full Arrow system on my 05. I tried to reposition everything but the mid pipe is touching the lower. What should i do about it?
 

·
Registered
Joined
·
208 Posts
on my 12 I had to trim on the lower to put a T-Force system on
 

·
Registered
Joined
·
3,152 Posts
Discussion Starter · #3 ·
I thought about cutting it but I would end up cutting out about 6" of my lower.

Can I space my lower out with a piece of rubber or something?
 

·
Registered
Joined
·
3,152 Posts
Discussion Starter · #6 ·
here is a pic of where it is touching. It is kind of hard to see





Here is a pic of the pipe just because
 

·
FEELING LUCKY, PUNK ?
Joined
·
5,739 Posts
have you tried loosing all the bolts and/or remounting it?
if you did and it still touches, just trim the lowers.. its not visible anyway.
or just leave it as it is and let it melt itself :dontknow: :badteeth:
 

·
Registered
Joined
·
3,152 Posts
Discussion Starter · #8 ·
I tried to adjust it and this is where I managed to get it to. Might need some more persuasion though.
 

·
Registered
Joined
·
3,152 Posts
Discussion Starter · #10 ·
I put down some insulated heat resistant tape...It seems to be holding up well...I'll see how it holds up over time
 

·
Registered
Joined
·
2,897 Posts
maybe try some of that exhaust wrap and put down there to keep it from melting the plastic??? of just build it up around down there with the heat tape.. theres somethign out there called Moose tape thats for high temp uses, If I remember the name correctly??
 
1 - 11 of 11 Posts
Top