Kawasaki ZX-10R Forum banner
1 - 1 of 1 Posts

·
Premium Member
'16 ZX-10R KRT
Joined
·
16,059 Posts
Well, yeah, I wouldn't use that tape measure either. Specifically because it's in inches and not metric.

But you're overthinking it. The bolt hole spacing is measured to the center point of the bolt hole, not the edges of it. So using a tape measure isn't accurate enough. It will get you close enough. The Gen 4/5 are the same. Order the one that they say will fit and don't worry so much about the exact spacing measurements.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top