Kawasaki ZX-10R Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
40 Posts
Discussion Starter #1
I've replaced by OEM dash (which si impossible to read during the day) with a Koso RX2n race dash and I'm thinking of wiring in a few LEDs for the FI, neutral and fuel lights but I'm not sure what the voltage is.

Is the signal (FI, neutral, etc) sent to the instrument cluster which powers these warning lights a 12V signal?
 

·
Registered
Joined
·
55 Posts
Isn't the proper answer. Chuck Norris doesn't ask what the voltage is, the 10R asks Chuck Norris what voltage he wants and then gives it to him. :crackup:
 

·
Registered
Joined
·
40 Posts
Discussion Starter #4
Neil Armstrong was the first man to walk on the moon but Chuck Norris was the first to walk on the sun!

I've measured the voltage by the way, 12V signal so resistors are needed to use separate LEDs.
 

·
Registered
Joined
·
40 Posts
Discussion Starter #6
Thanks, I've got the 06-07 Gen2 and I've already got the service manual.

I measured the voltage and its definitely 12V.
 
1 - 6 of 6 Posts
Top