Kawasaki ZX-10R Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
76 Posts
Discussion Starter #1
Oh wisdomerrs and wise beholders!

Can some one please share there vast knowledge on the following Wizardry/sourcery...

1) Which Gen i.e 3/4 wheels fit a gent 2 front and back?

2) Which manufactures appart front the holyness of brembo on a 320mm dimension break disks are there in the kingdom for the front wheel?

Kindest regards...
 

·
REPOST Enforcement Mod
Joined
·
13,667 Posts
Being that the Gen 2 is now over 13 years old, it is hard to find many on the road with people still knowledgeable about something like that. From my memory back when it was popular, the Gen 3 wheels should work. I think the front is good to go and the rear just needs the the spacers and axle to work with the bearing size differences. Best bet is to start searching and reading up the older threads and figure it out from there. Most of the people who did it back then aren't around here any more to answer direct questions. We'll see who comes out of the woodwork to respond here though.
 

·
REPOST Enforcement Mod
Joined
·
13,667 Posts

 

·
Registered
Joined
·
1,336 Posts
Both G2 & G3 wheels wheels bearings axle spacers identical. I know done that many times. Galfer discs are plenty some in the UK at the right price.
 
1 - 9 of 9 Posts
Top