Kawasaki ZX-10R Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1,836 Posts
Discussion Starter #1
Did these today and decided to do a how to. I took as many pictures as possible to make it really easy to follow. Hopefully someone can use this or encourage someone to do their own install and save some money on labor.

1. Remove side panels



2. Remove the seat



3. Remove the top bolt on the tank





4. Prop the tank and disconnect the the fuel pump and gas line











5. Disconnect the bottom bolt on the gas tank



6. Remove the gas tank and place it in a safe place



7. Locate the gray plug on the left side and unplug them



8. Remove the white covers on both sides with a small screwdriver









9. Push the two middle, centered pins out on both connectors





10. Plug the wires in the new connectors



11. Put the white plastic covers back on the gray plug



12. Plug the gray connector back together



13. Run the red wire to the positive battery terminal



14. Plug the GIPRO to the two connectors



15. Route the unit to the dash and run the wire for a clean install



16. Program if needed



17. Pat yourself on your back and go for a ride

:thumbsup:
 

·
Registered
Joined
·
1,836 Posts
Discussion Starter #2
Did these today and decided to do a how to. I took as many pictures as possible to make it really easy to follow. Hopefully someone can use this or encourage someone to do their own install and save some money on labor.

1. Remove side panels



2. Remove the seat



3. Remove the top bolt on the tank





4. Prop the tank and disconnect the the fuel pump and gas line











5. Disconnect the bottom bolt on the gas tank



6. Remove the gas tank and place it in a safe place



7. Locate the gray plug on the left side and unplug them



8. Remove the white covers on both sides with a small screwdriver









9. Push the two middle, centered pins out on both connectors





10. Plug the wires in the new connectors



11. Put the white plastic covers back on the gray plug



12. Plug the gray connector back together



13. Run the red wire to the positive battery terminal



14. Plug the GIPRO to the two connectors



15. Route the unit to the dash and run the wire for a clean install



16. Program if needed



17. Pat yourself on your back and go for a ride

:thumbsup:
 
1 - 2 of 2 Posts
Top