[lenshead]

Hey All,

Measuring clearances and found a couple intakes at .210 mm

Middle of the range for intake is .185 (.15 to .22)

Should I change the shim that single 0.025mm step, to put those intakes right at mid range?

Or is it enough that .21 is less than .22 ??

Am I overthinking this?

 

[White Fang]

Use the chart and pick the shim that puts the valve at the middle of the range, optimal spec.

 

[Bottoms-Up]

Hey All,

Measuring clearances and found a couple intakes at .210 mm

Middle of the range for intake is .185 (.15 to .22)

Should I change the shim that single 0.025mm step, to put those intakes right at mid range?

Or is it enough that .21 is less than .22 ??

Am I overthinking this?

Limit is .15 ~ .22 and you are at .21

Perfect leave it alone.

Valves tighten with use. If anything you want them on the loose end.

If it was at .16 I'd probably would go ahead and change.

If on the looser end you don't have to be so concerned for a while.

 

[scout]

I don't worry about them.

 

[CanyonCarver]

Valves tighten with use. If anything you want them on the loose end.

:+1:

This.

:thumbsup: