Kawasaki ZX-10R Forum banner

1 - 11 of 11 Posts

·
Registered
Joined
·
32 Posts
Discussion Starter #1
Can Someone Please Lend A Hand? I Have An Akro Carbon Slip On, And Want To Shorten It. What Is The Easiest Way? My Dad Has A Band Saw, Would That Be The Easiest Way, And Do I Just Drill Out The Rivots, And Drill New Holes/ Place New Ones, Any Help Is Appreciated Thanks
 

·
Registered
Joined
·
5,228 Posts
That would be how I would do it. Can you just buy an evo2 can? Maybe trade somebody?
 

·
Registered
Joined
·
2,473 Posts
once u take off the band on the end of the can, it will never be right again. so watch for leaks. not sure if u can buy them somewhere either...
 

·
Registered
Joined
·
1,459 Posts
Pulling of the caps is pain in the ass if it's anything like my Yoshi, invest in a good rubber hammer and a heat gun...
 

·
Registered
Joined
·
1,369 Posts
Brandon said:
once u take off the band on the end of the can, it will never be right again. so watch for leaks. not sure if u can buy them somewhere either...
exhaust tape. go to a auto store.
 

·
Registered
Joined
·
956 Posts
Mustard said:
Pulling of the caps is pain in the ass if it's anything like my Yoshi, invest in a good rubber hammer and a heat gun...
:+1: I shortened my Yosh and it was a Beotch!! I used just a dremel tho. :dontknow:
 
1 - 11 of 11 Posts
Top