Kawasaki ZX-10R Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
680 Posts
Discussion Starter #1
The instructions seemed simple enough. Bought it off a forum member and he couldn't remember the exact hookup. Took the bike apart and finally found out he didn't send me the connector with the red wire. Went back in to do it after I got it and it seems there are a bunch of extra wires, an extra connector and stuff out of place. Can someone point me in the right direction?

Instructions:
 

Attachments

·
Registered
Joined
·
680 Posts
Discussion Starter #2
The GIpro harness and wires:

2012-04-05_14-18-46_750.jpg

The connector I received had the red wire only, so I connected the green/red and black into it as instructed.

2012-04-05_14-19-10_945.jpg


Third picture is everything I'm looking at.

2012-04-05_14-21-54_340.jpg

Seems it should be simple as taking two wires from the factory harness and plugging them in the GIpro's. Maybe I'm missing something. Help appreciated. Thanks!
 

·
Registered
Joined
·
694 Posts
its because you need u remove some pin from the stock connector to plug it in the gi connector... i used the instruction that you have and it took me less than 10 minute and im not a mechanic..
 

·
Registered
Joined
·
12 Posts
After reading the instructions over I realized I was overlooking the male connectors in the plug under the F.I. rail I didn't pull out :headshake

But Thanks for the Great Support!

Pics installed, Available If someone is interested.
 
1 - 6 of 6 Posts
Top