Kawasaki ZX-10R Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
346 Posts
Discussion Starter #1
hello,i am in the process of installing a barnett clutch in my 98 zx9, the problem i ran into is that one of the fiber plates in the barnett clutch is different than the others. all the stock ones are the same. so i dont know if the different fiber plate goes in first or last. i talked to barnett and a kawi dealer about this and they dont know!!! barnett told me the stock clutch should have a different plate and i should just put in the new clutch in the same order. but the stock clutch does not have a different plate,i comfirmed this at the dealer. has anybody done this before, any help would be greatly appreciated. i am holding off puting it together until i know for sure. i would hate to take a guess and mess everything up. thank you all for your help..
 

·
Registered
Joined
·
1,167 Posts
:dontknow: I replaced my 99 zx9r about a year &1/2 ago but I went back stock, call barnett again and If they don't have the help for you i'd send it back and put stock back in
 
1 - 2 of 2 Posts
Top