Kawasaki ZX-10R Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
169 Posts
Discussion Starter #1
A while back I put a Gipro on my 04 10R. The instruction recommend remapping, but say it isn't mandatory.

I only have a K&N filter and Yosh RS3 slip-on. The current map I have is for "stock or aftermarket filter w/slip-on".

Does anyone know where I can get a map for the Gipro with my set-up?

I am guessing it will make little differnce, but it's worth a try.
 

·
Registered
Joined
·
1,775 Posts
There is a post about this back n forth and then some. I remember reading about this and about the secondary all wrapped into one post...
It was under Performance or the How to section
 

·
Registered
Joined
·
1,971 Posts
I wouldnt worry about it. Not that big of a change.
 

·
Registered
Joined
·
169 Posts
Discussion Starter #4
There is a post about this back n forth and then some. I remember reading about this and about the secondary all wrapped into one post...
It was under Performance or the How to section
Thanks for the info. I'll do some digital leg work...
 

·
Registered
Joined
·
169 Posts
Discussion Starter #5
I wouldnt worry about it. Not that big of a change.
Thanks for your thoughts. I am doubting it will be noticable, but if I can find a map, it is an easy test.

I am stationed in Germany, so I am for sure not gonna take it and have it dyno tuned with the sucky dollar-euro exchange rate. It would easily get into the hundred of dollars.
 
1 - 5 of 5 Posts
Top