Kawasaki ZX-10R Forum banner

Gen5 full exhaust on gen4

2K views 3 replies 3 participants last post by  Snakes709 
I had the Yoshimura Alpha 3/4 exhaust for the gen 5 on my gen4. Just had to remove the donut gasket out of the collector, use some gasket sealer and good to go. As you already mentioned the mounting point under the rear set wouldn't line up. But the bracket on the passenger peg holds it perfectly.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top