Kawasaki ZX-10R Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
Hey guys! Any knowledgeable folks know if i can throw a gen4 front end on to gen5? I did hear something about headstock change and inserts but not 100%
 

·
Registered
Joined
·
415 Posts
Good idea to replace everything if you have gen4 race forks, race calipers, wheel because separately they are not compatible.
Forks in clamps on gen5 are few mm more apart too.
Maybe someone can measure gen5 clamp shaft diameters and length. I can measure gen4 stock clamp shaft.
 

·
Registered
Joined
·
7 Posts
Discussion Starter · #5 ·
It's just a matter of needing a front end and getting a cheap deal on an entire Gen 4 front end. Take a step backwards to get two steps forward.
 

·
Registered
Joined
·
2,187 Posts
have seen gen4 with the entire gen5 front end...

I would guess that your gen5 would fit the gen4 front end (triples and forks)....
 

·
Я - Ребен&#108
2021 ZX10R Street & 2016 ZX10R KRT Race build
Joined
·
3,748 Posts
Im in the middle of converting my Gen 4 Race Bike into a Gen 5...
I have the Gen 5 for street.

I was going to make a thread once I work on the front.
Tail section took a while.








 
1 - 7 of 7 Posts
Top