Kawasaki ZX-10R Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter #1
So I've got a 2012 ZX10 ABS and have bypassed the ABS unit but i'd like to actually remove it.

Does anyone know how this can be done? is it a case of non-abs wiring loom or wat is required?
 

·
Registered
Joined
·
3,385 Posts
So I've got a 2012 ZX10 ABS and have bypassed the ABS unit but i'd like to actually remove it.

Does anyone know how this can be done? is it a case of non-abs wiring loom or wat is required?
If I can add this to my bike I would buy everything

Any know if you can add this ?
 

·
Registered
Joined
·
427 Posts
Kordo; You have to leave the ABS control unit plugged in, otherwise the bike will not rev over like 10,000 rpm, and you will have other problems. The only way you can remove the control unit is to replace the entire bike wiring harness with one from a non ABS model. Mike.
 

·
Registered
Joined
·
10 Posts
Discussion Starter #4
Kordo; You have to leave the ABS control unit plugged in, otherwise the bike will not rev over like 10,000 rpm, and you will have other problems. The only way you can remove the control unit is to replace the entire bike wiring harness with one from a non ABS model. Mike.
well i'm looking to race loom it and am planning on buying a new loom... so if the entire loom it changed for a non-abs model will it work? or will the dash/ecu throw codes
 

·
Shorty's Performance
Joined
·
8,860 Posts
I took everything off my 2013 zx14r and everything works perfectly fine, the engine works and performs perfectly fine.
 
1 - 5 of 5 Posts
Top