Joined
·
111 Posts
I'm looking to put a Gen3 steering damper on my Gen2. If I use Gen 2 mounts will it work just fine? Bought my bike used and it has no steering damper.
Gen3 Ohlins on Gen2
1 - 1 of 1 Posts
1 - 1 of 1 Posts
Join the discussion
Recommended Reading
-
>> Bottoming Out Forks <<
Suspension and Tire TechSo I had OEM forks & shock rebuilt with K-Tech springs to my weight, and I just got them installed. I have yet to tune them or even set sag, and I know I need more preload in the front as I've bottomed them out twice while braking over a bump in the middle of the same corner entrance. I'll be...- 10
- 627
-
Melampus · updated
-
2016 ZX10R Jumpy Ride
Suspension and Tire TechHi all, this issue is driving me nuts. I bought the bike 3 weeks ago, was a demo bike with 200miles on the clock. Everything was smooth, ran the rest in to the book. Serviced, no problems. Then stably 1700 miles, I pulled over at a service station and when setting off the bike started to feel...- 12
- 2K
-
girgis2000 · updated
-
Gen 5 Rear Wheel Removal
Suspension and Tire TechSo I have changed my rear tire on the zx10 at least a half dozen times already and I think 2 out of the 6 times it went back together smoothly... What tricks are you guys doing to keep the caliper and spacers in line? The clearance between the swingarm is super tight and doesn't allow for any...- 14
- 944
-
Woodcraft clipons
Suspension and Tire TechI am considering switching to woodcraft clipons. I like where the stock bars are but i need to replace my left one after an accident. I watched the video on Revzilla about Woodcraft clipons and they mentioned that some manufacturers have odd riser heighths so...does anyone know if the standard...- 3
- 230
-
Usmcgrunt47 · updated
-
Fork reservoir removal
Suspension and Tire TechSorry if this has been covered, but is there a set of caps to allow removal of the reservoir and adjusters on a stock gen 5 fork with cartridges installed?- 0
- 183
Join now to ask and comment!