Joined
·
65 Posts
Just finished installing a Gen 6 tail section on my Gen 5.
Gen 6 ZX10R tail swap on my Gen 5 ZX10R
1 - 11 of 11 Posts
Joined
·
65 Posts
4 - parts that make up the tail
1- Front seat
1-Rear fender undertail
Silver part of the rear subframe only not that sides .
Seat bracket
I bought all the hardware bolts washers etc but you don’t need them , you can use your stock ones .
1- Front seat
1-Rear fender undertail
Silver part of the rear subframe only not that sides .
Seat bracket
I bought all the hardware bolts washers etc but you don’t need them , you can use your stock ones .
Joined
·
65 Posts
Rear seat / seat cowl from the Gen 5 fits and tail light .
Joined
·
65 Posts
Partzilla has the lowest prices
The 4 pieces of tail section part numbers are for the black tail , if you need the green tail then you will need different part numbers .
The 4 pieces of tail section part numbers are for the black tail , if you need the green tail then you will need different part numbers .
Attachments
Joined
·
65 Posts
Sides
Attachments
Joined
·
46 Posts
The tail section is easy as they are the same subframe, but the rest of the fairings are much harder as the air intake snorkel and dash are completely different gen 5 to gen 6.
I have to replace those anyway so I though I might give it a shot. My fairing stay and dash are both broken.
Joined
·
65 Posts
The silver part of the subframe is different on the Gen 6 .
1 - 11 of 11 Posts
Join the discussion
