Kawasaki ZX-10R Forum banner

Gen 4 clutch in a Gen 5

1145 Views 4 Replies 2 Participants Last post by  MPac
It's time to do my clutch in my gen 5 as it finally bit the bullet on the strip, everything I've seen is showing that gen 4 is the same stack height as the Gen 5, I have an extra Cycle Concepts Drag Pak with springs for my 2011, will this work in my gen 5? I've found certain things from my '11 will bolt right up such as my strap and lowering link, etc so am I correct that I can drop this in?

Also some searching brought up in another thread that someone had a post about everything that will fit between gen 4 and 5, but I can't find it in the search?

Thanks in advance.
1 - 5 of 5 Posts
Check the OEM part numbers between GEN4 and GEN5:

2014 Kawasaki NINJA ZX-10R (ZX1000JEF) Clutch | Babbitts Kawasaki Partshouse

2016 Kawasaki NINJA ZX-10R ABS (ZX1000SGFA) Clutch | Babbitts Kawasaki Partshouse

I have an aftermarket kit ready to go in my GEN5 when it finally gives up and it's the same kit as I put in my GEN4.
This makes me so happy to hear I didn't throw away money, have any of you guys used the clutch mod? Is it worth it on the life of the clutches?
Also there is like a two plates to with small springs in between it, I'm assuming it's a cushion, my '11 didn't have that in the stack so where in the order of plates and fibers should that go?
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top