Kawasaki ZX-10R Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter #1
guys a mate of mine has a quickshifter and ignition modual for a pc5.
Is there anyway it can be spliced into a pc3? or is it totaly different in its workings
Thanks for any help
 

·
Registered
Joined
·
1 Posts
pc5 qs is easy, I THINK its the top two outside pins on the pinout plug that you connect the qs wires to. (dont quote me, its been a while) but never done (or seen) an ign module so no clue on that one.

sorry, good luck. =)
 

·
Registered
Joined
·
881 Posts
If the quickshifter sensor is normally close,it won't work. Some PCVs had these type of sensors. You a normally open sensor to work with the PC-III.

The ignition module won't work.
 
1 - 5 of 5 Posts
Top