Kawasaki ZX-10R Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
Hi, I have recently noticed the exhaust servo motor has an issue. Switch on the ignition and it cycles through its full movement ok. When it returns to the closed position it apears to be constantly hunting for the stop position. It does not move noticably but can be heard working under the seat. I realise that I can remove the servo and replace with an eliminator but would rather keep it on. Any thoughts?
 

·
OMG Look at that squid!!
Joined
·
2,595 Posts
I've seen this behavior on some of my 10's in the past. I never paid much attention to it. If I don't get a service light and the bike runs normally, just ride it. Or, pull the flapper and cables out, leave the servo plugged in. Or yea, an eliminator. Or a flash... lots of options.
 
1 - 2 of 2 Posts
Top