Kawasaki ZX-10R Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
15 Posts
Discussion Starter #1
Hey y'all I finally found a new engine for my 09 zx10r and I have dropped the old one out but I am having issues getting the new one lined up and into the the frame. This is my first time doing this so I'm learning throughout the process but I have all the wires and connecting taped, I have plenty of picture of how everything goes I just can't get this engine in and lined up! Any help or tips would be awesome!
 

·
Registered
Joined
·
2,164 Posts
Move all the adjusters as far into the frame as possible. Get one of the rear mounts lined up first and put the bolt through. You should then be able then lift the engine by the front to get the second rear mounting bolt in and the front two. A small car jack will make life easiest for getting the second bolt in, the first ones a bitch.
 
1 - 3 of 3 Posts
Top