Kawasaki ZX-10R Forum banner

1 - 7 of 7 Posts

·
inappropriate
Joined
·
7,728 Posts
Discussion Starter #1
Im trying to wire my VEYPOR VR1 data unit through my bike. In order to connect the RPM sensor to the bike i need to wire it one of two ways, either wire tap it to the ignition coil or wire tap to the tachometer wire at the tachometer harness itself. questions; what method do you guys recommend and where do i find the proper wires?
 

·
Rent this space
Joined
·
6,590 Posts
Take a pulse signal from the ECU , I dont remember what color off hand, but any one of 4 ignition driver wires will do the job.
 

·
inappropriate
Joined
·
7,728 Posts
Discussion Starter #3

·
inappropriate
Joined
·
7,728 Posts
Discussion Starter #5
is that wire 7 from that chart i found?
 

·
inappropriate
Joined
·
7,728 Posts
Discussion Starter #7
i ran it along the #2 coil. the project was running late last night so i had to stop short of an ops check. ill keep you guys posted. thanks
 
1 - 7 of 7 Posts
Top