Kawasaki ZX-10R Forum banner
1 - 2 of 2 Posts

· Registered
41 Posts
Discussion Starter · #1 ·
hi folks,

got a quick question.

My fuel tank is off being painted and i'm putting my new engine in tomorrow and i really want to run it up and check it's ok.. However becuase it's a submerged fuel pump i'm thinking of how to rig one up..

anyone any suggestions?

I was thinking of cutting a hole in one of those plastic fuel containers and use a big o-ring to seal it up.. only needs to run for a few mins up to temp..

anyone got any better ideas?
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.